JMHZ-TF2Z397EN
Page 2 of 2
4 Settings
4.1 Finger Opening/Closing Speed Adjustment
Use a flat blade screwdriver for adjusting the metering valves.
Ensure that the restriction of the two metering valves is approximately
the same. If they differ too much, the operation can become unstable.
Figure 5
5 How to Order
Refer to the customer drawings
for ‘How to Order’.
6 Outline Dimensions
Refer to the customer drawings
for outline dimensions.
7 Maintenance
7.1 General maintenance
Caution
Not following proper maintenance procedures could cause the product
to malfunction and lead to equipment damage.
If handled improperly, compressed air can be dangerous.
Maintenance of pneumatic systems should be performed only by
qualified personnel.
Before performing maintenance, turn off the power supply and be sure
to cut off the supply pressure. Confirm that the air is released to
atmosphere.
After installation and maintenance, apply operating pressure and
power to the equipment and perform appropriate functional and
leakage tests to make sure the equipment is installed correctly.
If any electrical connections are disturbed during maintenance, ensure
they are reconnected correctly and safety checks are carried out as
required to ensure continued compliance with applicable national
regulations.
Do not make any modification to the product.
Do not disassemble the product, unless required by installation or
maintenance instructions.
Warning
When air grippers are removed for maintenance, first confirm that
measures are in place to prevent any workpieces from dropping, run-
away of equipment. Then cut off the supply pressure and electric
power and exhaust all compressed air from the system using the
residual pressure release function. When the equipment is restarted,
proceed with caution after confirming that appropriate measures are in
place to prevent cylinders from sudden movement.
Do not allow people to enter or place objects in the carrying path of the
air gripper. Otherwise injury or accident may occur.
Do not put hands in between the air gripper fingers or attachments.
8 Limitations of Use
8.1 Limited warranty and disclaimer/compliance requirements
Refer to Handling Precautions for SMC Products.
9 Product Disposal
This product shall not be disposed of as municipal waste. Check your
local regulations and guidelines to dispose this product correctly, in order
to reduce the impact on human health and the environment.
10 Contacts
Refer to www.smcworld.com or www.smc.eu for your local
distributor/importer.
URL :
https:// www.smcworld.com (Global) https:// www.smc.eu (Europe)
SMC Corporation, 4-14-1, Sotokanda, Chiyoda-ku, Tokyo 101-0021, Japan
Specifications are subject to change without prior notice from the manufacturer.
©
2021
SMC Corporation All Rights Reserved.
Template DKP50047-F-085M
magnified view of the
matering valve
Adjustment groove
(for flat blade screwdriver)
