![background image](http://html.mh-extra.com/html/smc-networks/izn10-series/izn10-series_operation-manual_1299609007.webp)
4. Mounting
4-1. Precautions for mounting
- 7 -
WARNING
Mounting
!
1. Provide required space for maintenance, wiring and piping at installation.
Install connector and One-touch fitting for air supply to allow removal and mounting of cable and tube.
Do not bend cable and tube at steep angles. Affix them straight, within the minimum bending radius to
prevent applying stress to the installation base of the connector and One-touch fitting.
Forcible installation and removal may cause malfunction, broken wires, fire or air leakage.
Minimum bending radius: Power supply cable
・・・・・・・・・・・・・
35 mm
(
Note: This is the allowable bending radius when affixing wiring at 20
o
C. If bending cable at lower
temperatures, excessive force may be applied to the connector even within or below the minimum
bending radius.
)
See instructions or catalog for minimum bending radius for tube.
2. If the product is mounted directly, mount it on a flat face.
If the mounting face has a concave, convex, distortion and/or step, excessive force is applied to the
product, which may cause damage and failure of the product. Also, dropping and other strong impact may
cause failure and accident.
3. Do not use in a place subject to noise (electromagnetic wave, surge etc.)
It may cause malfunction, or deteriorate or damage internal elements. Take measures to prevent noise
sources and prevent lines from touching and mixing together.
4. Tighten within the specified torque.
See the following table for the tightening torque. When exceeding the tightening torque, mounting screws,
mounting bracket, etc. may be broken. The screw may loosen if tightened less than prescribed torque
range.
Screw size
Recommended
tightening torque
M3
0.61 to 0.63 Nm
5. Do not allow foreign matter or tools to enter the nozzle.
The inside of the nozzle has electrode needles. If a metal tool makes contact with the electrode needles, it
can cause electric shock, resulting in a sudden movement by the operator that can cause further injures by
such as hitting its body to peripheral equipment. Also, if the tool damages the electrode needle, the
product may fail or cause an accident.
6. Do not attach tape or seal on the product body.
If conductive adhesive or reflective paint is contained in the tape or seal, dielectric phenomenon will occur
due to the produced ion and it may lead to electrostatic charge and electric leakage.
7. Be sure to cut off the power supply before installing and adjusting the product.
CAUTION
1. Be sure to check for proper charge elimination after mounting the product.
The charge-elimination effect largely depends on ambient mounting conditions, operating conditions, etc.
After mounting the product, check for proper charge elimination.
Particularly, if there is a wall near the product, emitted ions can not reach a charged object for effective
!
High voltage
The electrode needles are subject to high voltage.
If a foreign matter is put in the nozzle and makes
contact with them, electric shock can make a
sudden movement by the operator, which can
cause injury. Therefore, do not to touch them.
Nozzle