![background image](http://html1.mh-extra.com/html/smc-networks/izd10-10-series/izd10-10-series_operation-manual_1298861009.webp)
8
Sensor head
Mate M3 bolt to the bolt mount surface. Mounting from the opposite side leads to cause the
breakage of the sensor head.
The sensor head body is common with GND due to the sensor structure. Attention should be
taken not to short c24V power source during installation and power supply.
Detection hole is closed to detect static electricity. If foreign material enter inside, and the hole
is touched with operation tools, the sensor can be damaged or malfunctioning which disables
correct detection of static electricity.
Do not pull the cable out of the sensor head, or turn it from the root of the head. They lead to
cause the sensor head breakage or disconnection.
5-1-2. Installation of the sensor amplifier
Mount the sensor amplifier with two M3 screws(prepare separately).
Recommended tightening torque for M3 screw. : 0.61 to 0.63Nm
Mate M3 bolt to the bolt mount surface. Mounting from the opposite side leads to cause the
breakage of the sensor amplifier.
Do not pull the cable out of the sensor amplifier, or turn it from the root of the amplifier. They
lead to cause the sensor amplifier breakage or disconnection.
Sensor amplifier case is common with FG. It shall be grounded with the ground resistance of
100ohms or less.
Recommended crimp terminal. : Crimp terminal with insulation coating made by Nichifu
TMEV1.25
-
3.
M3 screws
Sensor head
Detection hole
Bolt mount surface
Sensor amplifier
M3 screw
Grounded with ground resistance of
100 ohms or less
Bolt mount surface
Sensor head