SMC Networks HRZ002-W1S-F, Operation Manual

Page: 133 / 196

HRX-OM-X010
Chapter 5 System Operation
HRZ Series 5.3 Operation Screen
5-11
5-11
5.3.9 Control Setting screen 1
This screen is displayed if the PUMP IV is set to PRESS or FLOW on the Initial Setting screen 3.
If PUMP IV is set to FREQ, this screen is not displayed and 5.3.11 Control Setting screen 3-1
(page 5-13 ) is displayed.
＜ＣＯＮＴＲＯＬ ＳＥＴ＞ ↕
ＴＥＭＰ ＳＰ ２５．０℃
ＯＦＦＳＥＴ ０．０℃
ＰＵＭＰ ＳＰ ２０．０ＬＰＭ
Figure 5-11 Control Setting screen 1
Table 5-9 Control Setting screen 1
No. Item Descriptions Setting Range Factory Default
1 TEMP SP
Allows the setting of circulating fluid
discharge temperature.
HRZ002-WS/W1S-F
：
-10.0 to 90.0 deg C
HRZ004/008/010-WS/W1S-F
：
-20.0 to 90.0 deg C
HRZ***-W2S-F :
10.0 to 60.0 deg C
HRZ008-L/L1-F :
-20.0 to 40.0 deg C
25.0 deg C
2 OFFSET
Allows the setting of OFFSET
value
* １
-20.0 to 20.0 deg C 0.0 deg C
3 PUMP SP
Allows the setting of circulating fluid
flow rate.
(When PUMP IV on
“Initial Setting
screen 3
” is set to FLOW.)
HRZ***-WS/W1S/W2S-F
：
10.0 to 40.0LPM/2.6~10.6GPM
HRZ008-L-F
：
15.0 to 40.0LPM/4.0~10.6GPM
HRZ008-L1-F
：
10.0 to 40.0LPM/2.6~10.6GPM
HRZ***-WS/W1S/W2S-F
：
20.0LPM/5.3GPM
HRZ008-L-F
：
30.0LPM/7.9GPM
HRZ008-L1-F
：
20.0LPM/5.3GPM
Allows the setting of circulating fluid
discharge pressure.
(When PUMP IV on
“Initial Setting
srceen 3
” is set to PRESS.)
0.10 to 1.00MPa
15~145PSI
0.10MPa
15PSI
[Tips]
In the case of using Offset Function, select any one of MODE 1 to 3 on No.3 of
“Initial Setting screen 1”. See “Chapter 8 8.4 Offset Function“ (page 8-14) for
details.(*1).
[▲] or [▼] key is used for selecting “Item.” And pressing [ENT] key enabling
changing the set point.
Unit of PUMP SP can be selected on “Initial Setting screen 1”. See “5.3.16 Initial
Setting screen 1
“ (page 5-18) for details.
1
3
2
POWER ON