HRX-MM-L012
Chapter 4 Service Procedure
HRGC Series
4.1 Precautions for whole work
4-1
Chapter 4 Service Procedure
4.1 Precautions for whole work
4.1.1
Preparation for work
Remove the panel which covers the part to be replaced and drain the
circulating fluid if necessary.
4.1.2
Check after work
After the work is completed, check the product can operate normally.
Unless otherwise specified, be sure to lockout or tag out the main
breaker.
When the panel is removed or mouted, be sure to wear protective
shoes and gloves to prevent injury with the edge of the panel.
After the product is stopped, there is still a danger of getting burnt (or
frostbitten) due to residual heat. Do not start work until the product
reaches normal temperature.
The panel must not be removed or mounted during the operation of
the product. While the product is in operation, some parts will get hot
or cold and a high voltage power supply will be applied, so there is a
risk of burns (or frostbite) and electric shock to the operator.
Summary of Contents for HRGC001-A Series
