English
English
2. Launch a loopback or diagnostics testing program and follow the
instructions given. Typically, the instructions will be similar to
the following:
a. Enter the number of test messages (frame packets) to
be sent (Between 1 – 1000)
b. Click on the START button
c. The program will send a testing message looped in
the copper segment, and display a pass/fail result
Remote Loopback
1. Test Condition setup – In order for the function to produce an
accurate result, set switches according to the table below:
Test Condition
DIP Switches
1
2
3
4
5
6
7
Converter A
OFF
FD
100
FD
OFF
OFF
OFF
Converter B
OFF
FD
100
FD
OFF
OFF
ON
2. Launch a loopback or diagnostics testing program and follow
the instructions given. Typically, the instructions will be similar
to the following:
a. Enter the number of test messages (frame packets) to
be sent (Between 1 – 1000)
b. Click on the START button
c. The program will send a testing message looped in
the fiber segment, and display a pass/fail result
Warning
Be sure to deactivate both local and remote both loopback test
functions for normal converter operations
NOTE:
On a PC, use a program such as Sniffer to conduct the tests.
Other methods include the use of SmartBits series testing
equipment. If you do not have access to either method, please
contact your vendor for advice.
Install the converter
This Converter utilizes ports with fiber and copper port connectors
functioning under Ethernet and/or Fast Ethernet protocols.
10/100BASE-TX Port
The 10/100BASE-TX port supports network speeds of either 10Mbps
or 100Mbps, and can operate in half- and full duplex transfer
modes. This port also offers automatic MDI/MDI-X crossover
detection that gives true "plug and play" capability - just plug-in
the network cable to the port and the port will adjust according to
end node device automatically. The RJ-45 connector is suitable for
UTP cable Category 3, 4, 5 or better.
100BASE-FX Port
The 100BASE-FX port adds a fiber Fast Ethernet link to your
network device. Compliant with IEEE 802.3u, this port can
transmits data at 100Mbps in full duplex mode across distances of
up to 2km over multi-mode fiber-optic cable. The fiber port has a
choice of three fiber connector types: ST, SC and WDM.
11
12
!