QuickServer Start-Up Guide
Page 28 of 32
Appendix B.4. Securing QuickServer with Password
Access to the FieldServer can be restricted by enabling a password on the FS-GUI Passwords page
–
click Setup and then Passwords in the navigation panel. There are 2 access levels defined by 2 account
names: Admin and User.
•
The Admin account has unrestricted access to the FieldServer.
•
The User account can view any FieldServer information but cannot make any changes or restart
the FieldServer.
The password needs to be a minimum of eight characters and is
case sensitive
.
If the password is lost, click cancel on the password authentication popup window, and e-mail the
password recovery token to
to receive a temporary password from the
Sierra Monitor support team. This will allow access to the FieldServer in order to set a new password.
Appendix B.5. Factory Reset Instructions
For FieldServer factory reset instructions, see
ENOTE - FieldServer Next Gen Recovery
Appendix B.6. Internet Browsers Not Supported
•
Internet Explorer 11 and prior versions
Figure 16: FS-GUI Passwords Page
Figure 17: Password Recovery Page