![background image](http://html1.mh-extra.com/html/smc-networks/ex260-sen2-x205/ex260-sen2-x205_operation-manual_1299338030.webp)
-29-
No.EX
※※
-OMX1001
■
EtherNet/IP
TM
Device Level Ring (DLR) function
This SI unit can be used as an EtherNet/IP
TM
compliant node for network rings with the DLR function.
To enable the DLR function, all the ring nodes need to be applicable to the DLR function.
Since all of the DLR function settings are performed by the Ring Supervisor, there is no need to perform any
settings to the SI unit. Refer to the manual for the Ring Supervisor for detailed settings.
■
EtherNet/IP
TM
QuickConnect
TM
function
This SI unit can be used as an EtherNet/IP
TM
compliant node for networks with the QuickConnect
TM
function.
To enable the QuickConnect
TM
function, it is necessary to perform the settings 1 to 3 to the SI units shown
below.
After satisfying the conditions 1 to 3, setting of the QuickConnect
TM
function compliant EtherNet/IP
TM
module
(master), according to the specified procedure, must be performed. Refer to the manual for the
EtherNet/IP
TM
module (master) for the specified operation procedure.
1. IP address setting
The IP address is set either using the manual setting of the IP address X/Y switch, or by remote control
(with the IP address X switch set to "000").
When setting the IP address by remote control, first obtain the IP address through the BOOTP/DHCP
Server, then select the Disable DHCP button to hold the IP address.
2. Communication setting
Disable the auto negotiation (A - N) of the ports being used, and set the communication speed to 100 Mbps,
and the communication method to full duplex. Change the EtherNet Link Object to the values shown below.
Make sure the value is set to "01000000" when the QuickConnect
TM
function is not used.
(1) BUS IN port setting
Class
ID
Inst
ID
Attr
ID
Access
Rule
Name
Semantics of Values
Quick
Connect
F6h
[EtherNet Link
Object]
1h
6h
Get/Set
Interface
Control
01000000 = A-N Enable (Default)
Not use
02006400 = A-N Disable,
Force 100 Mbps Full duplex
Use
(2) BUS OUT port setting
Class
ID
Inst
ID
Attr
ID
Access
Rule
Name
Semantics of Values
Quick
Connect
F6h
[EtherNet Link
Object]
2h
6h
Get/Set
Interface
Control
01000000 = A-N Enable (Default)
Not use
02006400 = A-N Disable,
Force 100 Mbps Full duplex
Use
3. Enabling the QuickConnect
TM
function
Change the TCP/IP Object to the values shown below.
Make sure the value is set to "0" when the QuickConnect
TM
function is not used.
Class
ID
Inst
ID
Attr
ID
Access
Rule
Name
Semantics of Values
Quick
Connect
F5h
[TCP/IP Object]
1h
Ch
Get/Set
EtherNet/IP
QuickConnect
0 = Disable (Default)
Not use
1 = Enable
Use