SMC Networks EliteConnect SMCE21011, User Manual, Page: 185 / 258

C
HAPTER
22
| Filtering Commands
– 185 –
DEC XNS, DEC-MOP-Dump-Load, DEC-MOP, DEC-LAT, Ethertalk,
Appletalk-ARP, Novell-IPX(old), Novell-IPX(new), EAPOL, Telxon-
TXP, Aironet-DDP, Enet-Config-Test, IP, IPv6, NetBEUI,
PPPoE_Discovery, PPPoE_PPP_Session)
D
EFAULT
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
Use the filter ethernet-type enable command to enable filtering for
Ethernet types specified in the filtering table, or the no filter ethernet-
type enable command to disable all filtering based on the filtering table.
E
XAMPLE
AP(config)#filter ethernet-type protocol ARP
AP(config)#
R
ELATED
C
OMMANDS
filter ethernet-type enabled (184)
show filters
This command shows the filter options and protocol entries in the filter
table.
S
YNTAX
show filters [acl-source-address | acl-destination-address]
C
OMMAND
M
ODE
Exec
E
XAMPLE
AP#show filters
Protocol Filter Information
=======================================================================
Local Bridge :Traffic among all client STAs blocked
AP Management :DISABLED
EtherType Filter :DISABLED
Enabled EtherType Filters
-----------------------------------------------------------------------
=======================================================================
AP#