C
HAPTER
22
| Filtering Commands
– 183 –
filter acl-source-
address mac-
address
This command enables filtering of source MAC addresses from the Ethernet
port.
S
YNTAX
[no] filter acl-source-address {add | delete} address
MAC address - Specifies a MAC address in the form xx-xx-xx-xx-xx-
xx.
A maximum of eight addresses can be added to the filtering table.
D
EFAULT
Disabled
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
AP(config)#filter acl-source-address add xx:xx:xx:xx:xx:xx
AP(config)#
filter acl-
destination-address
enable
This command enables filtering ACL destination addresses from the
Ethernet port.
S
YNTAX
[no] filter acl-source-address {enable | disable}
D
EFAULT
Disabled
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
AP(config)#filter acl-destination-address enable
AP(config)#
filter acl-
destination-address
mac-address
This command enables filtering of destination MAC addresses from the
Ethernet port.
S
YNTAX
[no] filter acl-destination-address {add | delete} address
MAC address - Specifies a MAC address in the form xx-xx-xx-xx-xx-
xx.
A maximum of eight addresses can be added to the filtering table.
Summary of Contents for EliteConnect SMCE21011
