![background image](http://html1.mh-extra.com/html/smc-networks/crb-40-a-series/crb-40-a-series_operation-manual_1299527030.webp)
25
No.
Size 10, 15, 20, 30, 40
Mounting for auto switch unit and auto switch
(Solid state switch D-M9)
Follow the procedure below in numerical order starting from 1 to
attach the auto switch unit.
(Note1. Auto switch of (4) is not included when ordering only a unit.)
(Note2. When the screw tightening torque is not specified, the
tightening torque shall be approx. 0.49Nm.)
(Note3. After the adjustment of the auto switch, hold the auto switch
still while fixing. Please refer to the cautions.)
Caution for mounting D-M9 auto switch
Correct mounting condition
Incorrect mounting condition
- Mount upright so that the auto switch is aligned with the
product.
- Not mounted in parallel to the center of the product.
If the auto switch is not mounted in parallel to the center of the
product, the switch will be displaced outward and the
operation will be affected.
Correct the mounting condition holding the switch referring to
the drawing on the left.
4. Auto switches (2pcs)
3. Cross recessed round
head screw (3pcs)
2pcs. for size 10
5. Slotted set screw (2pcs)
Note: The tightening torque
should be 0.05 to 01 (Nm)
6. Cross recessed round
head screw (2pcs)
(Fixed temporarily)
2. Hexagon socket set screw (1pc)
(Fixed to 1 temporarily)
1. Magnet lever (1pc)
Note:
Size 10,15
The tightening torque should be 0.49 (Nm)
Size 20,30,40
The tightening torque should be 0.8 (Nm)
Parallel to the center of the product
(recommended condition for mounting)
Not parallel to the center of the product
(Not the correct position - Re assemble)
Summary of Contents for CRB 40-A Series
Page 7: ...2 Applicable auto swiches...