IP Interface Commands
41-32
41
clear ipv6 neighbors
This command deletes all dynamic entries in the IPv6 neighbor discovery cache.
Command Mode
Privileged Exec
Example
The following deletes all dynamic entries in the IPv6 neighbor cache:
Address Resolution Protocol
(ARP)
This section describes commands used to configure ARP on the switch.
arp
This command adds a static entry in the Address Resolution Protocol (ARP) cache.
Use the
no
form to remove an entry from the cache.
Syntax
arp
ip-address
hardware-address
no arp
ip-address
•
ip-address
- IP address to map to a specified hardware address.
•
hardware-address
- Hardware address to map to a specified IP address.
(The format for this address is xx-xx-xx-xx-xx-xx.)
Default Setting
No default entries
Command Mode
Global Configuration
Command Usage
• The ARP cache is used to map 32-bit IP addresses into 48-bit hardware (i.e.,
Media Access Control) addresses. This cache includes entries for hosts and
other routers on local network interfaces defined on this router.
• The maximum number of static entries allowed in the ARP cache is 128.
Console#clear ipv6 neighbors
Console#
Table 41-7 Address Resolution Protocol Commands
Command
Function
Mode
Page
arp
Adds a static entry in the ARP cache
GC
41-32
arp timeout
Sets the time a dynamic entry remains in the ARP cache
GC
41-33
clear arp-cache
Deletes all dynamic entries from the ARP cache
PE
41-34
show arp
Displays entries in the ARP cache
NE, PE 41-34
ip proxy-arp
Enables proxy ARP service
VC
41-35
Summary of Contents for 8926EM
