![background image](http://html1.mh-extra.com/html/smc-networks/8724m-int-annexe-1/8724m-int-annexe-1_installation-manual_1300713046.webp)
I
NSTALLING
THE
S
WITCH
3-10
Connecting to a Power Source
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC receptacle located at the
back of the switch.
Figure 3-7 Power Receptacles
2. Plug the other end of the cable into a grounded, 3-pin socket, AC power
source.
Note:
For International use, you may need to change the AC line cord. You
must use a line cord set that has been approved for the receptacle
type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure the
PWR LED is lit. If not, check that the power cable is correctly plugged
in.
4. If you have purchased a Redundant Power Unit, connect it to the switch
and to an AC power source now, following the instructions included with
the package.
100-240V~ 50-60Hz 1.5A
RPU
DC
12V 4.5A
Summary of Contents for 8724M INT - annexe 1
