R
OUTER
R
EDUNDANCY
C
OMMANDS
-217
before attempting to take over as the master is three times the hello
interval plus half a second
Example
vrrp preempt
Use this command to configure the router to take over as the master
virtual router for a VRRP group if it has a higher priority than the current
acting master router. Use the
no
form to disable preemption.
Syntax
vrrp
group
preempt
[
delay
seconds
]
no
vrrp
group
preempt
•
group
- Identifies the VRRP group. (Range: 1-255)
•
seconds
- The time to wait before issuing a claim to become the
master. (Range: 0-120 seconds)
Default Setting
Preempt: Enabled
Delay: 0 seconds
Command Mode
Interface (VLAN)
Command Usage
• If preempt is enabled, and this backup router has a priority higher than
the current acting master, it will take over as the new master. However,
note that if the original master (i.e., the owner of the VRRP IP address)
comes back on line, it will always resume control as the master.
• The delay can give additional time to receive an advertisement message
from the current master before taking control. If the router attempting
to become the master has just come on line, this delay also gives it time
to gather information for its routing table before actually preempting
the currently active router.
Console(config-if)#vrrp 1 timers advertise 5
Console(config-if)#
Summary of Contents for 8612XL3
