-206
ip pim hello-holdtime
Use this command to configure the interval to wait for hello messages
from a neighboring PIM router before declaring it dead. Use the
no
form
to restore the default value.
Syntax
ip pim hello-holdtime
seconds
no ip pim hello-interval
seconds
- The hold time for PIM hello messages. (Range: 1-65535)
Default Setting
105 seconds
Command Mode
Interface Configuration (VLAN)
Command Usage
The
ip pim hello-holdtime
should be 3.5 times the value of
ip pim
hello-interval
(page 3-205).
Example
ip pim trigger-hello-interval
Use this command to configure the maximum time before transmitting a
triggered PIM Hello message after the router is rebooted or PIM is
enabled on an interface. Use the
no
form to restore the default value.
Syntax
ip pim triggerr-hello-interval
seconds
no ip pim triggerr-hello-interval
seconds
- The maximum time before sending a triggered PIM Hello
message. (Range: 0-65535)
Console(config-if)#ip pim hello-holdtime 210
Console(config-if)#
Summary of Contents for 8612XL3
