-192
Syntax
router dvmrp
no router dvmrp
Command Mode
Global Configuration
Command Usage
This command enables DVMRP globally for the router and enters
router configuration mode. Make any changes necessary to the global
DVMRP parameters. Then specify the interfaces that will support
DVMRP multicast routing using the
ip dvmrp
command, and set the
metric for each interface.
Example
Related Commands
ip dvmrp (3-197)
show router dvmrp (3-199)
probe-interval
Use this command to set the interval for sending neighbor probe messages
to the multicast group address for all DVMRP routers. Use the
no
form to
restore the default value.
Syntax
probe-interval
seconds
Console(config)#router dvmrp
Console(config-router)#end
Console#show router dvmrp
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway : 0.0.0.0
Metric of Default Gateway : 0
Console#
Summary of Contents for 8612XL3
