-112
reduced value results in reduced time to detect the loss of the last
member of a group.
Example
The following shows how to configure the maximum response time to
10 seconds:
ip igmp version
Use this command to configure the IGMP version used on an interface.
Use the
no
form of this command to restore the default.
Syntax
ip igmp version
{
1
|
2
}
no ip igmp version
•
1
- IGMP Version 1
•
2
- IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Interface Configuration (VLAN)
Command Usage
• All routers on the subnet must support the same version. However, the
multicast hosts on the subnet may support either IGMP version 1 or 2.
• The switch must be set to version 2 to enable the
ip igmp
max-resp-interval
(page 3-110).
Console(config-if)#ip igmp last-memb-query-interval 10
Console(config-if)#
Summary of Contents for 8612XL3
