-62
Example
The following example shows how to set the PVID for port 1 to VLAN 3:
switchport allowed vlan
This command configures VLAN groups on the selected interface. Use
the
no
form to restore the default.
Syntax
switchport allowed vlan
{
add
vlan-list
[
tagged
|
untagged
] |
remove
vlan-list
}
no switchport allowed vlan
•
add
vlan-list
- List of VLAN identifiers to add.
•
remove
vlan-list
- List of VLAN identifiers to remove.
•
vlan-list
- Separate nonconsecutive VLAN identifiers with a comma
and no spaces; use a hyphen to designate a range of IDs. Do not
enter leading zeros. (Range: 1-4094).
Default Setting
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• A port, or a trunk with switchport mode set to
hybrid
, must be
assigned to at least one VLAN as untagged.
• If a trunk has switchport mode set to
trunk
(i.e., 1Q Trunk), then you
can only assign an interface to VLAN groups as a tagged member.
• Frames are always tagged within the switch. The tagged/untagged
parameter used when adding a VLAN to an interface tells the switch
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
Summary of Contents for 8612XL3
