VLAN C
OMMANDS
-61
Example
The following example shows how to set the interface to port 1 and then
enable ingress filtering:
switchport native vlan
This command configures the PVID (i.e., default VLAN ID) for a port.
Use the
no
form to restore the default.
Syntax
switchport native vlan
vlan-id
no switchport native vlan
vlan-id
- Default VLAN ID for a port. (Range: 1-4094, no leading
zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If an interface is not a member of VLAN 1 and you assign its PVID to
this VLAN, the interface will automatically be added to VLAN 1 as an
untagged member. For all other VLANs, an interface must first be
configured as an untagged member before you can assign its PVID to
that group.
• If acceptable frame types is set to
all
or switchport mode is set to
hybrid
, the PVID will be inserted into all untagged frames entering the
ingress port.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport ingress-filtering
Console(config-if)#
Summary of Contents for 8612XL3
