S
PANNING
T
REE
C
OMMANDS
-47
the maximum value for path cost is 65,535.
Example
spanning-tree port-priority
This command configures the priority for the specified interface. Use the
no
form to restore the default.
Syntax
spanning-tree port-priority
priority
no spanning-tree port-priority
priority
- The priority for a port. (Range: 0-240, in steps of 16)
Default Setting
128
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command defines the priority for the use of a port in the Spanning
Tree Algorithm. If the path cost for all ports on a switch are the same,
the port with the highest priority (that is, lowest value) will be
configured as an active link in the spanning tree.
• Where more than one port is assigned the highest priority, the port with
lowest numeric identifier will be enabled.
Example
Related Commands
spanning-tree cost (3-46)
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree cost 50
Console(config-if)#
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-priority 0
Summary of Contents for 8612XL3
