S
PANNING
T
REE
C
OMMANDS
-43
Default Setting
20 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a device can wait
without receiving a configuration message before attempting to
reconfigure. All device ports (except for designated ports) should
receive configuration messages at regular intervals. Any port that ages
out STA information (provided in the last configuration message)
becomes the designated port for the attached LAN. If it is a root port,
a new root port is selected from among the device ports attached to the
network.
Example
spanning-tree priority
This command configures the spanning tree priority globally for this
switch. Use the
no
form to restore the default.
Syntax
spanning-tree
priority
priority
no spanning-tree
priority
priority
- Priority of the bridge. (Range: 0 - 65535)
(Range – 0-61440, in steps of 4096; Options: 0, 4096, 8192, 12288,
16384, 20480, 24576, 28672, 32768, 36864, 40960, 45056, 49152,
53248, 57344, 61440)
Default Setting
32768
Console(config)#spanning-tree max-age 40
Console(config)#
Summary of Contents for 8612XL3
