-24
lacp system-priority
This command configures a port's LACP system priority. Use the
no
form
to restore the default setting.
Syntax
lacp
{
actor
|
partner
}
system-priority
priority
no lacp
{
actor
|
partner
}
system-priority
•
actor
- The local side an aggregate link.
•
partner
- The remote side of an aggregate link.
•
priority
- This priority is used to determine link aggregation group
(LAG) membership, and to identify this device to other switches
during LAG negotiations. (Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Port must be configured with the same system priority to join the same
LAG.
• System priority is combined with the switch’s MAC address to form the
LAG identifier. This identifier is used to indicate a specific LAG during
LACP negotiations with other systems.
• Once the remote side of a link has been established, LACP operational
settings are already in use on that side. Configuring LACP settings for
the partner only applys to its administrative state, not its operational
Current status:
Created by: lacp
Link status: Up
Operation speed-duplex: 1000full
Flow control type: None
Member Ports: Eth1/10, Eth1/11, Eth1/12,
Console#
Summary of Contents for 8612XL3
