-22
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When configuring static trunks, the switches must comply with the
Cisco EtherChannel standard.
• Use
no channel-group
to
remove a port group from a trunk.
• Use
no interfaces port-channel
to remove a trunk from the switch.
Example
The following example creates trunk 1 and then adds port 11:
lacp
This command enables 802.3ad Link Aggregation Control Protocol
(LACP) for the current interface. Use the
no
form to disable it.
Syntax
[
no
]
lacp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#
Summary of Contents for 8612XL3
