R
ATE
L
IMIT
C
OMMANDS
-19
by the hardware to verify conformity. Non-conforming traffic is dropped,
conforming traffic is forwarded without any changes.
rate-limit
This command defines the rate limit for a specific interface. Use this
command without specifying a rate to restore the default rate. Use the
no
form to restore the default status of disabled.
Syntax
rate-limit
{
input
|
output
} [
rate
]
no rate-limit
{
input
|
output
}
•
input
– Input rate
•
output
– Output rate
•
rate –
Maximum value in Mbps. (Range: 1 to 1000 Mbps)
Default Setting
1000 Mbps
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Command
Function
Mode Page
rate-limit
Configures the maximum input or output rate for
a port
IC
3-19
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 600
Console(config-if)#
Summary of Contents for 8612XL3
