-4
Default Setting
• Auto-negotiation is enabled by default.
• When auto-negotiation is disabled, the default speed-duplex setting is
100half for 100BASE-TX ports and 1000full for Gigabit Ethernet
ports.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• To force operation to the speed and duplex mode specified in a
speed-duplex
command, use the
no negotiation
command to disable
auto-negotiation on the selected interface.
• When using the
negotiation
command to enable auto-negotiation, the
optimal settings will be determined by the
capabilities
command. To
set the speed/duplex mode under auto-negotiation, the required mode
must be specified in the capabilities list for an interface.
Example
The following example configures port 5 to 100 Mbps, half-duplex
operation.
Related Commands
negotiation (3-4)
capabilities (3-5)
negotiation
This command enables autonegotiation for a given interface. Use the
no
form to disable autonegotiation.
Syntax
[
no
]
negotiation
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Summary of Contents for 8612XL3
