DHCP C
OMMANDS
4-163
within the range of a configured network address pool.
Example
Related Commands
network (3-163)
host (3-170)
network
Use this command to configure the subnet number and mask for a DHCP
address pool. Use the
no
form to remove the subnet number and mask.
Syntax
network
network-number
[
mask
]
no network
•
network-number
- The IP address of the DHCP address pool.
•
mask
- The bit combination that identifies the network (or subnet)
and the host portion of the DHCP address pool.
Command Mode
DHCP Pool Configuration
Usage Guidelines
• When a client request is received, the switch first checks for a network
address pool matching the gateway where the request originated (i.e., if
the request was forwarded by a relay server). If there is no gateway in
the client request (i.e., the request was not forwarded by a relay server),
the switch searches for a network pool matching the interface through
which the client request was received. It then searches for a manually
configured host address that falls within the matching network pool. If
no manually configured host address is found, it assigns an address
from the matching network address pool. However, if no matching
address pool is found the request is ignored.
Console(config)#ip dhcp pool R&D
Console(config-dhcp)#
Summary of Contents for 8612XL3
