C
OMMAND
L
INE
I
NTERFACE
4-162
•
high-address
- The last IP address in an excluded address range.
Default Setting
All IP pool addresses may be assigned.
Command Mode
Global Configuration
Example
ip dhcp pool
Use this command to configure a DHCP address pool and enter DHCP
Pool Configuration mode. Use the
no
form to remove the address pool.
Syntax
ip dhcp pool
name
no ip dhcp pool
name
name
- A string or integer. (Range: 1-8 characters)
Default Setting
DHCP address pools are not configured.
Command Mode
Global Configuration
Usage Guidelines
• After executing this command, the switch changes to DHCP Pool
Configuration mode, identified by the (config-dhcp)# prompt.
• From this mode, first configure address pools for the network
interfaces (using the
network
command). You can also manually bind
an address to a specific client (with the
host
command) if required. You
can configure up to 8 network address pools, and up to 32 manually
bound host address pools (i.e., listing one host address per pool).
However, note that any address specified in a
host
command must fall
Console(config)#ip dhcp excluded-address 10.1.0.19
Console(config)#
Summary of Contents for 8612XL3
