C
OMMAND
L
INE
I
NTERFACE
4-152
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an
snmp-server enable traps
command, no
notifications controlled by this command are sent. In order to
configure this device to send SNMP notifications, you must enter at
least one
snmp-server enable traps
command. If you enter the
command with no keywords, both authentication and link-up-down
notifications are enabled. If you enter the command with a keyword,
only the notification type related to that keyword is enabled.
• The
snmp-server enable traps
command is used in conjunction with
the
snmp-server host
command. Use the
snmp-server host
command to specify which host or hosts receive SNMP notifications.
In order to send notifications, you must configure at least one
snmp-server host
command.
Example
Related Commands
snmp-server host (3-150)
snmp ip filter
This command sets the IP addresses of clients that are allowed
management access to the switch via SNMP. Use the
no
form the remove
an IP address.
Syntax
[
no
]
snmp ip filter
ip_address
subnet_mask
•
ip_address
- An IP address indicating a client or group of clients that
Console(config)#snmp-server enable traps link-up-down
Console(config)#
Summary of Contents for 8612XL3
