A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-131
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can change frame
priorities based on an ACL rule.
• Traffic priorities may be included in the IEEE 802.1p priority tag. This
tag is also incorporated as part of the overall IEEE 802.1Q VLAN tag.
To specify this priority, use the
set priority
keywords.
• The IP frame header also includes priority bits in the Type of Service
(ToS) octet. The Type of Service octet may contain three bits for IP
Precedence or six bits for Differentiated Services Code Point (DSCP)
service. To specify the IP precedence priority, use the
set tos
keywords.
To specify the DSCP priority, use the
set dscp
keywords. Note that the
IP frame header can include either the IP Precedence or DSCP priority
type.
• The precedence for priority mapping by this switch is IP Precedence or
DSCP Priority, and then 802.1p priority.
Example
Related Commands
show marking (3-131)
show marking
This command displays the current configuration for packet marking.
Command Mode
Privileged Exec
Console(config)#interface ethernet 1/12
Console(config-if)#match access-list ip bill set dscp 0
Console(config-if)#
Summary of Contents for 8612XL3
