A
CCESS
C
ONTROL
L
IST
C
OMMANDS
4-129
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
Command Usage
• You must configure an ACL mask before you can map CoS values to
the rule.
• A packet matching a rule within the specified ACL is mapped to one of
the output queues as shown in the following table. For information on
mapping the CoS values to output queues, see
queue cos-map
on
page 3-81.
Example
Related Commands
queue cos-map (3-81)
show map access-list ip (3-129)
show map access-list ip
This command shows the CoS value mapped to an IP ACL for the current
interface. (The CoS value determines the output queue for packets
matching an ACL rule.)
Syntax
show map access-list ip
[
interface
]
interface
Priority
0
1
2
3
4
5
6
7
Queue
1
2
0
3
4
5
6
7
Console(config)#interface ethernet 1/2
Console(config-if)#map access-list ip bill cos 0
Console(config-if)#
Summary of Contents for 8612XL3
