L
INE
C
OMMANDS
4-25
Syntax
stopbits
{
1
|
2
}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
disconnect
Use this command to terminate an SSH, Telnet, or console connection.
Syntax
disconnect
session-id
session-id
– The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
Command Mode
Privileged Exec
Command Usage
Specifying session identifier “0” will disconnect the console
connection. Specifying any other identifiers for an active session will
disconnect an SSH or Telnet connection.
Example
Console(config-line)#stopbits 2
Console(config-line)#
Console#disconnect 1
Console#
Summary of Contents for 8612XL3
