![background image](http://html.mh-extra.com/html/smc-networks/6624fmst/6624fmst_management-manual_1300650229.webp)
9-39
Configuring Advanced Features
Stack Management
C
o
nf
ig
u
ring Adva
nc
ed
Featu
res
Syntax:
stack member <
switch-number
>
mac-address <
mac-addr
>
[password<
password-str
>]
In the destination Commander, use
show stack all
to find the MAC address of
the Member you want to pull into the destination stack. For example, suppose
you created a new Commander with a stack name of “Cold_Waters” and you
wanted to move a switch named “Bering Sea” into the new stack:
Figure 9-32. Example of Stack Listing with Two Stacks in the Subnet
You would then execute the following command to pull the desired switch
into the new stack:
SMC6624M(config)# stack member 1 mac-address 0060b0-
df1a00
Where
1
is an unused switch number (
SN
).
Since a password is not set on the Candidate, a password is not needed in this
example.
You could then use
show stack all
again to verify that the move took place.
Using a Member CLI To “Push” the Member into Another Stack.
You
can use the Member’s CLI to “push” an SMC6624M stack Member into a
destination stack if you know the MAC address of the destination Commander.
Syntax:
stack join
<mac-addr>
where:
<mac-addr>
is the MAC address of the Commander for the desti-
nation stack.
Converting a Commander to a Member of Another Stack.
Removing
the Commander from a stack eliminates the stack and returns its Members to
the Candidate pool with
Auto Join
disabled.
SMC6624M(config)# show stack all
Stacking - Stacking Status (All)
Stack Name
MAC Address
System Name
Status
--------------- ------------- ------------------------- --------------------
Big_Waters
0030c1-7fec40 SMC6624M
Commander Up
0060b0-880a80 Indian Ocean
Member Up
0060b0-df1a00 Bering Sea
Member Up
Cold_Waters
0030c1-7fc700 Cold_waters-0
Commander Up
Move this switch into the “Cold Waters” stack.