13 - 89
13. POSITIONING MODE
13.8 Point table setting method
This section provides the method for setting the point table by using set up software(MR Configurator2
TM
).
POINT
Positioning mode is supported by set up software(MR Configurator2
TM
) with
software Ver.1.52E or later.
The value of the parameter No. PE02 set on the parameter setting screen is
not interlocked with the STM (feed length multiplication) value on the point
table list screen. Set the STM (feed length multiplication) value to the same
as set in the parameter No. PE02 on the point table list screen.
Click "Positioning-data" on the menu bar, and click "Point table" on the menu.
When the above choices are made, the following window appears.
1) Changing point table data
Click the data to be changed, enter a new value into the input field, and press the enter key.
2) Writing point table data
Click the point table data changed, and click the "Selected Items Write" button to write the new point
table data to the driver.
3) Batch-writing point table data
Click the "Write All" button to write all point table data to the driver.
4) Batch-reading point table data
Click the "Read" button to read and display all point table data from the driver.
5) Verifying point table data
Click the "Verify" button to verify all data being displayed and the data of the driver.
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
(14)
