iSmartIMMO 801 User Manual
l
15
5.2 IMMO Programming
The iSmartIMMO G3 is required when performing this operation. It has the
following functions:
• Read transponder data (including Mercedes Benz infrared smart key), and
generate exclusive keys.
• Read/write on-board EEPROM chip data, and read/write MCU/ECU chip data.
• Read/write remote control transponder data and detect key frequency.
1. Before performing this function, please make sure the following connections
are properly made.
A. Main diagnostic cable
B. OBD I adaptor
C. Switching power supply of the iSmartIMMO G3
Notes:
•
You are suggested to connect the VCI dongle shown in below diagram to the
tablet via the USB cable. Using a USB cable could effectively enhance your data
transmission speed.
•
IMMO Programming does not require a connection to the vehicle. To ensure
that the iSmartIMMO G3 works properly, ONLY use the switching power
supply and OBD I adaptor to supply power to the iSmartIMMO G3. Obtaining
power through a connection to the DC power jack of the iSmartIMMO G3 via
the switching power supply alone is failed.
2. Tap
Anti-theft programmer
to enter the following screen.