SmarTrunk Systems ST-9116C, Service Manual, Page: 14 / 67

ST-9116C SM R 1.1 SMARTRUNK SYSTEMS, INC. 14
5. ST-9116 ALIGNMENT
5.1. INTRODUCTION
The ST-9116 series are carefully
aligned at the factory for the
specified performance across the
frequency range depending for each
version.
Realignment should
therefore not be necessary except in
the event of a component failure, or
altering version type.
All component replacement and
service should be performed only by
an
authorized SmarTrunk
representative, or the warranty
policy may be void.
The following procedures cover the
sometimes critical and tedious
adjustments that are not normally
required once the repeater has left
the factory.
However, if damage occurs and
some parts subsequently are
placed,
realignment may be
required. If a sudden problem
occurs during normal operation, it
is likely due to component failure;
realignment should not be done
until after the faulty component has
been replaced.
We recommend that servicing be
performed only by authorized
SmarTrunk service technicians
who are experienced with the
circuitry and fully equipped for
repair and align. Therefore, if a fault
is suspected, contact the dealer
from whom the transceiver was
purchased
for instructions
regarding repair. Authorized
Smartrunk service technicians
realign all circuits and make
complete performance checks to
ensure compliance with factory
specifications after replacing any
faulty components.
Those who do undertake any of the
following alignments are cautioned
to proceed at their own risk.
Problems caused by unauthorized
attempts at realignment are not
covered by the warranty policy.
In addition, SmarTrunk reserves
the right to change circuits and
alignment
procedures in the
interest of improved performance,
without notifying owners.
Under no circumstances should
any alignment be attempted unless
the normal function and operation
of the transceiver are clearly
understood, the cause of the
malfunction has been clearly
pinpointed
and any faulty
components replaced, and
realignment determined to be
necessary.
5.2. ALIGNMENT:
The following test equipment (and
thorough familiarity with its correct
use) is necessary for complete
realignment.
Correction of
problems caused by misalignment
resulting from use of improper test
equipment is not covered under the
warranty policy.
While most steps do not require all
of the equipment listed, the
interactions of some adjustments
may
require that complex
adjustments be performed
afterwards. Do not attempt to
perform only a single step unless it