Smartrise DSD412, Startup Manual

Page: 11 / 22

Drive Startup Manual DSD412
March 5, 2020 ©2020 Smartrise Engineering, Inc. All Rights Reserved Page 3
Brake
Perform the following to connect the brakes. See the C4 Controller sheet 05 Brakes for job
specific information.
•
Connect the main brake wiring to terminal K1 / K2 and the secondary brake wiring (if
equipped) to terminals J1 / J2 located on the terminal block next to the M Contactor.
•
Jump EB to the terminal listed in the construction box (see the C4 Controller sheet 01
Getting Started ) and connect either the rope gripper or sheave brake to the EBR (if
installed).
Motor / Encoder
Perform the following to connect the drive to the motor and encoder cable. See the C4
Controller sheet 04 Drive and Motor for job specific information.
• Connect motor leads to the M contactor at T1/T2/T3.
• Connect the encoder cable to the TB1 encoder terminal block located under the lower
cover.
The table below lists the Wiring References for Common Encoders.
Table 1: Wiring References for Common Encoders
Encoder Drive Imperial 35’
Imperial
50’ / 75’
Accucoder Wachendorff IH740 /
IH950
Industrial
PWR IP Red White Brown Brown Brown Brown
COM IG Black Black Blue White White White
A A+ White Purple White Green Green Green
/A A- White/Black Gray Green Red Pink Pink
B B+ Blue Green Yellow Yellow Yellow Yellow
/B B- Red/Black Blue Gray Black Blue Blue
Z Orange Gray Gray Gray
/Z Green Violet Red Red
CLK+ CK
CLK-
CK
DAT+ DT
DAT-
DT
SHIELD FE Shield Shield Shield Shield Shield Shield