HGM9120 Genset Controller
HGM9120 Genset Controller Version: 1.0 2014-04-14 Page 40 of 58
7.2 ENABLE DEFINITION OF PROGRAMMABLE OUTPUT PORTS
Form 2
No.
Type
Description
0
Not Used
1
Custom Period 1
Details of function description please see the
following.
2
Custom Period 2
3
Custom Period 3
4
Custom Period 4
5
Custom Period 5
6
Custom Period 6
7
Custom Combined 1
8
Custom Combined 2
9
Custom Combined 3
10
Custom Combined 4
11
Custom Combined 5
12
Custom Combined 6
13
Reserved
14
Reserved
15
Reserved
16
Reserved
17
Air Flap
Action when over speed shutdown and
emergence stop. It also can close the air
inflow to stop the engine as soon as possible.
18
Audible Alarm
Action when warning, shutdown, trips. Can be
connected
annunciator externally. When
“alarm mute” configurable input port is active,
it can remove the alarm.
19
Louver Control
Action in genset starting and disconnect when
genset stopped completely.
20
Fuel Pump Control
It is control
led by fuel pump of level sensor‟s
limited threshold.
21
Heater Control
It is controlled by heating of temperature
sensor‟s setting bound.
22
Cooler Control
It is controlled by cooler of temperature
sensor‟s setting bound.
23
Oil Pre-supply Output
Actions in period of cranking to safety run.
24
Excite Generator
Output in start period. If there is no generator
frequency during hi-speed running, output for
2 seconds again.
25
Pre-Lubricate
Actions in period of pre-heating to safety run.
26
Remote PC Output
This port is controlled by communication (PC).
27
GSM Power
Power for GSM module (GSM module is reset
when GSM communication failed).
28
Reserved
