Option 1:
Connect via Soundwave
(Available for indoor cameras only)
Enter your Wi-Fi network and password.
Ensure the volume/ringer on your phone is
turned up and the room is quiet. Hold your
phone near the camera. Press “Play Sound”.
An audible sound will play, passing the Wi-Fi
credentials from your phone to the camera
via the built in camera microphone.
Step 3: Connect Your Camera
Plug the camera into the power outlet using
the included AC Power Adapter. Wait 60
seconds for the camera to enter enroll mode.
Next, select how you wish to connect the
camera. There are 3 ways to connect the
camera to Wi-Fi; via WPS, via Soundwave, or
via IP (recommended when available).
Alternatively you can connect permanently
over IP using the included Ethernet cable.
Step 2: Enter Camera DID
Enter the camera DID number by either
selecting “Scan QR Code” or “Enter Manually”.
Scanning will use your smartphone camera
to scan the QR code from the camera label.
Once entered, an alert will display confirming
the camera DID. Select “OK” and then “Next”
to continue.
Wireless Camera
Installation Guide
Step 1: Choose Your Camera
From the mobile app, once signed in,
navigate to the “Settings” page. Select “Add
Camera” and choose the corresponding
image that matches your camera.
Once selected, enter the desired camera
name on the following page and press “Next”.
Some indoor cameras have a Wi-Fi indicator light which will flash slowly when in
enroll mode. If not flashing, unplug your camera, plug back in and wait 60 seconds to
re-initiate enroll mode. The Wi-Fi light will remain solid when successfully connected.
!
Option 2:
Connect Wi-Fi
®
via IP or
Connect permanently via IP
(Available for outdoor, most indoor cameras)
Plug your camera into your router using the
included Ethernet cable.
If connecting over Wi-Fi, enter your network
and password credentials before continuing.
The camera will receive the Wi-Fi credentials
through the IP connection.
Once successfully connected, remove the
Ethernet cable and AC power cable. Wait 15
seconds, then plug the AC power only back
into the camera.
If connecting the camera via Wi-Fi
®
, the camera must be on a 2.4Ghz network. If
using a dual-band router, do not use the 5Ghz network. Make sure your smartphone
is connected to the same Wi-Fi network you want to connect the camera to.
!
If the camera is already powered up, unplug it now. 60 seconds after powering up
the camera, it will enter enroll mode for the next 5 minutes. You must complete
Step 3: Connect Your Camera within this 5 minute time window.
!