CHAPTER 2
INSTALLING YOUR SMART ROOM SYSTEM
18
smarttech.com/kb/170764
NOTE
The microphone status light on the camera is lit green when the camera is receiving power, but it
doesn’t indicate the status of the microphones.
Connecting the audio processor
The table microphones are typically located
on the meeting room table, and the speakers
are located on either side of the interactive
flat panels. The table microphones and
speakers are connected to the audio
processor, which is connected to the room
computer though a USB cable.
IMPORTANT
Connect the audio processor to the room computer using the provided USB cable. SMART
recommends that you do not use a USB hub or extender to extend the length of the USB
connection.
After you connect the audio processor to the room computer, set the table microphones as the
default audio input device and the speakers as the default audio output device.
NOTE
This procedure may vary depending on your version of Windows operating system and your
system preferences.
To set the table microphones and speakers as the default audio devices
1. Open Control Panel.
2. Press Hardware and Sound, and then press Sound.
The
Sound
dialog box appears.
3. Press Playback.
4. Right-click Echo Canceling Speakerphone, and then select Set as Default Device.
