A P P E N D I X B
Connecting your room control system to your projector
90
smarttech.com/kb/170295
Command
Command target range
Response
set micvolume [target]
=0 to =40
micvolume=[target]
set mute [target]
=on
=off
mute=[target]
set volumecontrol [target]
=on
=off
volumecontrol=[target]
set cc [target]
=cc1
=cc2
cc=[target]
set lineoutenable [target]
=on
=off
lineoutenable=[target]
set micenable [target]
=on
=off
micenable=[target]
set speakerenable [target]
=on
=off
speakerenable=[target]
set microboostenable
=on
=off
microboostenable=[target]
N O T E
Typically,
cc1
displays U.S. English subtitles, while
cc2
displays other regional languages, such
as French or Spanish, depending on television channel or media setup.
Network controls
These commands control your projector’s network status and settings. These settings are located in
the OSD menu, and are available even when the projector is in Standby mode. You must locally set
the network commands to on for the network abilities to work
These commands inform you of the current network settings.
Command
Response
get netstatus
netstatus=connected
netstatus=disconnected
netstatus=disabled
get network
network=[current VGA and network outputs status]
get dhcp
dhcp=[current DHCP status]
get ipaddr
ipaddr=[current IP address]
get subnetmask
subnetmask=[current subnet mask number]
