SMART Board MX Pro Series, Installation And Maintenance Manual, Page: 111 / 115

Appendix D
Managing SMART Board MX series displays using RS-232
smarttech.com/kb/171555 112
With the exception of get powerstate and set powerstate , commands are available only when the
display is in ON power state.
Commands
Get command Set command Response
get powerstate set powerstate[Value]
Where
[Value]
is one of the following:
l
= on
l
= ready
NOTES
l
If the command returns an “invalid
command” message, add spaces
around the operator symbol (=).
l
When the screen is in a low power
state, it doesn’t respond to any
RS-232 commands. Disable
Power saving mode to prevent
the display from entering a low
power state. See
Power saving
mode on page 92.
l
If the display is in UPDATEON or
UPDATEREADY state, it might not
change power states after it
receives the command.
powerstate=[Value]
Where
[Value]
is one of the following:
l
on
l
ready
l
updateon
l
updateready
get input set input[Value]
Where
[Value]
is one of the following:
l
=OPS
l
=OPSCC
l
=HDMI1
l
=HDMI2
l
=HDMI3
l
=VGA
input=[Value]
Where
[Value]
is one of the following:
l
=OPS
l
=OPSCC
l
=HDMI1
l
=HDMI2
l
=HDMI3
l
=VGA
l
=ANDROID
NOTES
l
=OPSCC
is only available if you
install an AM50 iQ appliance and
compute card.
l
=ANDROID is the display’s
settings.