SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016
64
Supported DSCP Values
The DSCP marking QoS Queue Management Configuration marking on ingress packets is based on the selection you make in the
Select
Default DSCP Mark
field. The selected default marking is applied automatically to all incoming packets without reference to a particular
classification.
Note:
A default DSCP mark value of
Default(000000)
will mark all egress packets that do NOT match any classification.
The following values are supported. For more information about commonly used DSCP values, refer to RFC 2475.
No Change(-1)
CS1(001000)
AF32(011100)
CS4
(100000)
Auto Marking(-2)
AF23(010110)
AF31(011010)
EF
(101110)
Default(000000)
AF22(010100)
CS3(011000)
CS5
(101000)
AF13(001110)
AF21(010010)
AF43(100110)
CS6
(110000)
AF12(001100)
CS2(010000)
AF42(100100)
AF11(001010)
AF33(011110)
AF41(100010)
QoS Queue Config
On this page you can configure a queue and add it to a selected Layer2 interface.
1. In the left navigation bar, click
Advanced Setup
>
Quality Of Service
>
QoS Queue Config
and then click
Add
. The following
page appears.