Smart Technologies SMART Board 480, User Manual

Page: 50 / 87

l
The projector isn’t connected to the power source.
l
The projector has an internal problem.
g
To resolve the unlit projector Power light issue
1. Check the power source, and then make sure that all cables are connected.
2. Confirm that the projector is connected to an active power outlet.
3. Make sure the pins on the connectors aren’t broken or bent.
4. Make sure the Hide Display feature on the remote is disabled. See Using the remote control
buttons on page 11.
5. If the previous steps don’t resolve the issue, disconnect the power cable and then contact your
authorized SMART reseller ( smarttech.com/wheretobuy ).
Resolving network communication issues
If you don’t have network access, perform the following procedure to troubleshoot your system.
g
To resolve network communication issues
1. Ensure that your network’s RJ45 cable is properly connected to the modular cable connection
on the projector’s connection panel.
2. Ensure that the LAN warning light on the projector is green. To activate the LAN, use the
“vgaoutnetenable=on” RS-232 command (see Projector programming commands on page 56)
or the “Network and VGA out” projector menu option (see Network menu on page 15). The
network function on the projector doesn’t work until you send one of these commands.
3. Press the Menu button, and then select the Network Settings menu to check the IP address.
See Network menu on page 15 for a description of the IP address field. Enter this IP address
into your browser or SNMP agent.
4. If you still don’t have network access, contact your network administrator. If your administrator
is unable to resolve the issue, contact your authorized SMART reseller
( smarttech.com/wheretobuy ).
C H A P T E R 6
Troubleshooting your interactive whiteboard system
40