2000i-DVX Installation Guide
13
Adjusting the Projected Image
CAUTION
Do
not
move the blue ring that surrounds the customized projector lenses, even
though the
NEC VT660K/VT560/VT465 User’s Manual
states that you should use this
ring to obtain the best focus. You must disregard this information because mvoing this
ring may cause the lenses to separate.
The Zoom lever on the projector has been modified to adjust image focus. Again,
contrary to the
NEC VT660K/VT560/VT465 User’s Manual
, the Zoom lever will
not
adjust the image size on the screen.
If the placement, size and shape of the projected image is less than optimal, you may need to
perform any of four adjustment procedures.
For the first three procedures (adjusting image roll, adjusting the image laterally and adjusting the
image size), you must watch the image on the back of the screen while making adjustments. You’ll
also need to remove the view port cover, which is attached with hook-and-loop fastener strips, to
access the adjustment hardware at the rear of the unit.
For the final procedure (adjusting the image vertically), adjust the image while watching it from the
front of the unit.
To focus the image
1. Locate the focus lever, at the bottom of the upside-down projector. Use this lever rather than the
blue focus ring to adjust the focus.
Do not move this ring!
Bottom View (Upside-Down)
Side View
Adjust the focus with this lever
VI
D
EO
S-
VI
DEO
AU
TO
AD
J.
RG
B
EN
TE
R
CA
NC
EL
SE
LE
C
T
ME
NU
LA
M
P
ST
AT
U
S
PO
W
E
R
ON
/S
TA
N
D
B
Y
Summary of Contents for SMART Board 2000i-DVX
Page 1: ...Interactive Whiteboard Guide Installation ...
Page 8: ......
