background image

M A N U A L   /   A U T O M A T I C

  T R A N S M I S S I O N   M U L T I - C H A N N E L  

R E M O T E   S T A R T E R   S Y S T E M  

INDUSTRY CANADA USER NOTICE: 

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this 
device must accept any interference, including interference that may cause undesired operation of the 
device. 
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that 
the equivalent isotropically radiated power (EIRP) is not more than that required for successful 
communication. 

NOTE:

 The manufacturer is not responsible for any radio or TV interference caused by unauthorized 

modifications to this equipment. Such modifications could void the user's authority to operate the equipment. 

Doc#: 110914 

Rev: 1.2 

© 2011 

-AS2272- 

-FcN- 

Canada 

AS2272

User Guide 

WARNING! 

It is the responsibility of the vehicle operator to ensure their vehicle 
is parked in a safe and responsible manner. 

1.

a) Manual transmission:

When leaving the vehicle, it is the user’s 

responsibility to ensure that the gearshift lever is in the 

NEUTRAL

position and the parking brake is engaged in order to avoid accidents 
upon remote starting. 

b) Automatic transmission:

 When leaving the vehicle, it is the user’s 

responsibility to ensure that the gearshift lever is in “Park” in order to 
avoid accidents upon remote starting. 
(

Note:

 Make sure that the automatic vehicle cannot start in "Drive".) 

2. It is the user's responsibility to ensure that the remote starter is 

disabled or put into valet mode before servicing.  

Designed & engineered in Canada 

P.12

User Guide 

ParkingLightFlashTable

Parking lights flashes 

Description

1

x

Doors locked. 

x

Trunk released. 

x

Start signal received from the remote. 

x

Runtime has expired 

2 slow 

x

Shutdown by remote 

2 fast 

x

Doors unlocked 

x

Valet mode is deactivated 

3 slow 

x

Runtime is extended. 

3 fast 

x

Valet mode activated. 

4 fast 

x

Shutdown by brake 

x

A remote start was attempted while the brake pedal is engaged. 

10 fast 

x

Shutdown by hood 

x

A remote start was attempted while the hood is open. 

ON

Î

 twice 

x

Cold weather mode deactivated 

ON

Î

 3 times 

x

Cold weather mode activated. 

Solid ON 

x

Engine is running under remote start. 

Flash for 30 sec. 

x

Panic mode is triggered. 

Note: The installer can also use the PRG-1000 to diagnose shutdown and remote 
start failures. Refer to the PRG-1000 manual guide. 

Summary of Contents for AS2272







Reviews: