A P P E N D I X A
Remotely managing your system through a network interface
48
Failurelog
This menu enables you to view projector service details such as lamp hours, display hours,
temperature and lamp voltage on failure types such as Lamp Error and System Overtemp.
Network settings
This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting
Description
DHCP
Determines whether the projector’s IP address and other network
settings are dynamically assigned by a DHCP server or are
manually set.
l
On
allows the network’s DHCP server to assign a dynamic
IP address to the projector.
l
Off
allows you to manually set the projector’s IP address and
other network settings.
IP Address
Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask
Displays or allows you to set the projector’s subnet mask number
in values between 0.0.0.0 and 255.255.255.255.
Gateway
Displays or allows you to set the projector’s default network
gateway in values between 0.0.0.0 and 255.255.255.255.
DNS
Displays or allows you to set the projector’s IP address for your
network’s primary domain name server in values between 0.0.0.0
and 255.255.255.255.
Group Name
Displays or allows you to set the projector’s workgroup name
(maximum 12 characters).
Projector Name
Displays or allows you to set the projector’s name (maximum 12
characters).
Location
Displays or allows you to set the projector’s location (maximum 16
characters).
