A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
59
E X A M P L E
>set brightness = 65
brightness=65
>set brightness vga1 = 65
brightness vga1 = 65
This sets the brightness of the VGA1 source whether the projector is on this source or not.
Audio control
Use these commands to set audio output controls. The range of values used for these
commands should match the range shown in the on-screen display (OSD).
Command/response definitions
Command
Response
Powered off
set volume [target]
volume=[current]
no
get volume
volume=[current]
no
set mute [target]
mute=[current]
no
get mute
mute=[current]
no
set volumecontrol
[target]
volumecontrol=
[current]
no
get volumecontrol
volumecontrol=
[current]
no
set cc [target]
cc=[current]
no
get cc
cc=[current]
no
set sysoutputsw
[target]
sysoutputsw=
[current]
no
get sysoutputsw
sysoutputsw=
[current]
no
