A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
54
> get videoinputs
videoinputs = vga1, composite, hdmi1
> get usb1source
usb1source = vga1
> get usb2source
usb2source = hdmi1
> set usb2source=hdmi1
usb2source = hdmi1
>
Video control
Use these commands to change your projector's video output controls. The range of values used
for these commands should match the range displayed in the on-screen display (OSD). The
firmware must handle videofreeze and videomute states correctly. A change should be made to
ensure that videofreeze and videomute are mutually exclusive.
Command/response definitions
Command
Response
Responds when powered off
set displaymode [target]
displaymode=[current]
no
get displaymode
displaymode=[current]
no
set brightness [target]
brightness=[current]
no
get brightness
brightness=[current]
no
set contrast [target]
contrast=[current]
no
get contrast
contrast=[current]
no
set frequency [target]
frequency=[current]
no
get frequency
frequency=[current]
no
set tracking [target]
tracking=[current]
no
get tracking
tracking=[current]
no
set saturation [target]
saturation=[current]
no
get saturation
saturation=[current]
no
set tint [target]
tint=[current]
no
get tint
tint=[current]
no
