A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
53
Field definitions
Field
Possible values
Description
current input
l
VGA1
l
Composite
l
HDMI1
l
None
A text list of available video source inputs.
None
is a non-selectable input and is returned
in response to a “get input” command when the
projector is turned off.
target input
l
= VGA1
l
= Composite
l
= HDMI1
l
= None
l
= Next
A text list of possible inputs. Selecting
Next
causes the projector to move to the next item
in the list and return a response equivalent to a
user-specified input.
current videoinputs
VGA1, Composite,
HDMI1, etc.
A comma-separated list of available projector
inputs. The strings returned in this command
must match the strings used for the input
selection from the on-screen display (OSD).
VGA1 and HDMI1 are local at the projector.
VGA2 and HDMI2 are at the UCP. The
maximum could be 10 inputs in the current list
(maximum of 14 is reserved).
current usb1source
l
VGA1
l
HDMI1
l
Disabled
Current value that the USB1 switch is enabled
for.
target usb1source
l
= VGA1
l
= HDMI1
l
= Disabled
Value to set the USB1-switch-enabled source
to. If this value is the same as the USB2
source, the USB1 source is used and the
USB2 source is ignored.
current usb2source
l
VGA1
l
HDMI1
l
Disabled
Current value of the USB2 switch.
target usb2source
l
= VGA1
l
= HDMI1
l
= Disabled
Value to set the USB2 switch enabled source
to. If this value is the same as the USB2
source, the USB1 source is used and the
USB2 source is ignored.
E X A M P L E
> set input=vga1
input = vga1
> set input=next
input = composite
