A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
62
smarttech.com/kb/170453
Network controls
These commands control the integration properties of the projector.
Usable command
by power state
Property
Valid values
Notes
Standby
/ idle
On
set or get
network
• on
• off (default)
Enables or disables the
network module.
set or get
set or get
vgaoutnetenable
• on
• off (default)
Same function as the “network”
property.
get
get
netstatus
• connected
• disconnected
• disabled
Reports if the network port on
the projector is or isn’t
connected to a network.
set or get
set or get
dhcp
• on
• off (default)
When off, the projector's
network IP address,
subnetmask, gateway and
primary DNS values must all be
set manually.
set or get
set or get
ipaddr
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
set or get
set or get
subnetmask
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
set or get
set or get
gateway
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
set or get
set or get
primarydns
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
An IPv4 address.
get
set or get
macaddr
xx-xx-xx-xx-xx-xx]
The media access control
(MAC) identifier of the
projector’s network module.
